L_TT1P_CrossCutter: Profile generator for offset does not adapt speed to master (eliminated from V3.17.0)

Eliminated from :
Library: L_TT1P_TechnologyModules (FAST Motion) from V03.17.00.47
(Update via Easy Package Manager)

Behviour of new version:
The profile generator continuously adapts to the speed of the master axis when moving offsets.

What happens?

In the L_TT1P_CrossCutter, the profile generator for offset execution does not adapt the speed to the master. As a consequence, the execution of the set offset may take longer.

When does this behaviour occur?

The master axis of the CrossCutter technology module is at standstill.
The CrossCutter technology module is clutched in.
A negative offset is selected. After this, the master axis is approached in positive direction.

Which products are affected?

Library: L_TT1P_TechnologyModules_LM (from V3.15.0.32)
TM L_TT1P_CrossCutter

Short-term measures:

When using the L_TT1P_CrossCutter TM, only set an offset in negative direction when the master axis is already being executed.

Evaluation/recommendations:

A short-term measure is available.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700336/1/

Meta data

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201700336
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.