L_MC2P - MC_GearInPos: Negative gearbox factor leads to setpoint position jumps of the slave axis (corrected from V3.14.2)

Corrected from:
Library:   L_MC2P_MotionControlCam  (FAST Motion)  V03.14.02.02
                      (update via Package Manager)
 
Response of the new version:
'MC_GearInPos': A steady setpoint position is output for the slave axis.
 
What happens?
'MC_GearInPos': The setpoint position output for the slave axis changes abruptly.
 
When does this behaviour occur?
The behaviour occurs if a negative gearbox factor (numerator / denominator) is selected.

Which products are affected?
Library:   L_MC2P_MotionControlCam  (FAST Motion) 
                       (contained in the PLC Designer)
 
Short-term measures:
Only select positive gearbox factor values. 
 
Evaluation/recommendations:
 

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700134/1/
Meta data
Taxonomy: Lib L_MC2P_MotionControlCam
AKB-ID: 201700134
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form