ECS Application-Software (A-SW) for ECS drive variants

Description
The ECS servo system is designed for a great variety of applications. Axis modules with 4 ideally-tailored drive variants are available for easy and efficient configuration and commissioning:
  • Speed and Torque for general servo applications
  • Posi and Shaft for positioning applications and electrical shaft or electrical gearbox
  • Motion for co-ordinated multi-axis applications
  • Application for an indivdual functionality adaptation. Freely programmable in the IEC 61131-3 languages.
The EASY Starter software can be used to load the required application into the ECS axis module. The 'Speed and Torque', 'Posi and Shaft', and 'Motion' drive variants are applications which have been prepared by Lenze. They can be downloaded from this contribution.

System requirements
EASY Starter (Application Loader) V1.2 or higher

Download
ECS_Applications_V10.zip (350 kB): Applications for the Speed and Torque (V1.0), Posi and Shaft (V1.2, V1.3, V2.0) and Motion (V1.1, V1.2, V2.0, V3.0, V4.0) drive variants

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201207235/1/
Meta data
Taxonomy: EASY Starter , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECSxA application
AKB-ID: 201207235
Last update: 2023/09/14
Category: Software Downloads

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.

Further information

Contact form