Remedied from:
Communication module Profibus E94AYCPM FW 1.20
Behaviour of the new version?
All errors/faults that are triggered by the module are now reset by the module independently as soon as the error/fault no longer exists. This applies to the error/fault responses of the type Information, Warning and Fault. The module faults/errors are entered in the 9400 Servo Drives logbook as before.
What happens?
Up to now, if the module triggers an error/fault, the latter has had to be reset by the user. However, this was unfortunately not visible on the Engineer user interface because only basicdevice faults/errors are shown here.
When does the problem occur?
The problem occurred when the following error/fault reactions (Information, Warning and Fault) to module faults/errors took place.
What products are affected?
Communication module E94AYCPM ≤ FW 1.11
Possible diagnostics?
None
Short-term measures/recommendations?
None
Evaluation:
Better handling is possible for the customer due to automatic reset of the error/fault reaction.
