L_TS2P_FlyingSawState: Parking position outside the working area (corrected from V3.26.0)

Corrected from:
Library:  L_TS2P_TechModulesSynchronizingCamming from V03.26.00
              (Update via EASY Package Manager)

Response of the new version:
Parking positions that are outside the lower travel range limit of the saw carriage (scPar.lrLowerLimit) and the upper travel range limit of the saw carriage (scPar.lrUpperLimit) are approached.
A warning indicates that the driving range limit has been undercut or exceeded.

What happens?
Parking positions that are outside the lower travel range limit of the saw carriage (scPar.lrLowerLimit) and the upper travel range limit of the saw carriage (scPar.lrUpperLimit) are not approached.
A warning indicates that the parking position (scPar.lrParkPosition) is outside the driving range limits.
 
When does the behaviour occur?
- Parking position (scPar.lrParkPosition) outside the driving range limits (scPar.lrLowerLimit, scPar.lrUpperLimit) parameterised
- Rising edge at input xMoveToParkPos
 
Which products are affected?
L_TS2P_FlyingSawState from library L_TS2P_TechMoulesSynchronizingCamming

Short-term measures:
- 

Evaluation / recommendations:
-

Automatic Translation

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202200136/1/
Meta data
Taxonomy: Lib L_CM1P_ControlModules , Lib L_TB1P_TechnologyBasics , Lib L_TB2P_TechModulesBasic , Lib L_TF2P_TechModulesFollowingPositioning , Lib L_TP2P_TechModulesProcessFunctions , Lib L_TS2P_TechModulesSynchronizingCamming , Lib L_TW2P_TechModulesWindingTraversing , FAST Motion Modules V2
AKB-ID: 202200136
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form