L_TB2P_TechModulesBasic: L_TB2P_AxisInterface does not fully support i700 (corrected from V03.20.00)

​Corrected from:
Library:  L_TB2P_TechModulesBasic  from V03.20.00.27
                (Update via Easy Package Manager)
 
Response of the new version:
The cyclic reading of the parameters specified below now also works on the controller if the corresponding process data is also available in the mapping.
- lrActualMotorCurrent
- lrDC_BusVoltage
- lrThermalLoadDevice
- lrThermalLoadMotor
- lrActualMotorTemperature
 
What happens?
FB L_TB2P_AxisInterface:  If the device on a controller is connected to an i700 or i550 at least the following values are not described by the device:
- lrActualMotorCurrent
- lrDC_BusVoltage
- lrThermalLoadDevice
- lrThermalLoadMotor
- lrActualMotorTemperature
 
When does the behaviour occur?
Using the FB L_TB2P_AxisInterface module on a controller.
 
Which products are affected?
Library:   L_TB2P_TechModulesBasic
 
Short-term measures, Evaluation/recommendations:
none
 
Automatic Translation

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201900257/1/
Meta data
Taxonomy: Lib L_CM1P_ControlModules , Lib L_TB1P_TechnologyBasics , Lib L_TB2P_TechModulesBasic , Lib L_TF2P_TechModulesFollowingPositioning , Lib L_TP2P_TechModulesProcessFunctions , Lib L_TS2P_TechModulesSynchronizingCamming , Lib L_TW2P_TechModulesWindingTraversing , FAST Motion Modules V2
AKB-ID: 201900257
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form