L_TT1P_BasicMotion: Parameter "lrJerkJog" has no effects (corrected from V03.17.00)

Corrected from:
Library: L_TT1P_TechnologyModules_LM V03.17.00.47

Response of the new version:

During manual operation, the lrJogJerk jerk parameter is now considered.

What happens?

The lrJerkJog jerk parameter does not have any effects.

When does this behaviour occur?

The axis is traversed manually (jog function) and the jerk shall be selected via the lrJerkJog parameter.

Which products are affected?
Library: L_TT1P_TechnologyModules_LM
(L_TT1P_BasicMotionBase technology module)

Short-term measures:

None. For the Jogging function, the jerk cannot be limited.

Evaluation/recommendations:

If the jogging function is used for commissioning and the axes are traversed with low acceleration and deceleration values, the function restriction has a slight effect on the path control of the axes.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201600183/1/

Meta data

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201600183
Last update: 2023/10/18
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.