L_TT1P_CrossCutter: Synchronous phase is limited to max. 50% (eliminated from V3.12)

Corrected from:

L_TT1P_TechnologyModules_LM V3.12.0.9

Response of the new version:

The limitation has been removed.

_______________________________________________________________________________________________

What happens?
The INVALID_PARMETER_CUTTING_ANGLE error message is output.

When does this behaviour occur?

The behaviour occurs if the technology module is configured with a synchronous phase greater than 50%. For the L_TT1P_CrossCutter technology module, the synchronous phase is limited to max. 50%.

Which products are affected?
L_TT1P_CrossCutter function block from L_TT1P_TablePositioning_LM library (V3.9.0.62 and higher)

Short-term measures:

Only configure synchronous phases lower than 50%.

Evaluation/recommendations:
The function restriction is prioritised as high and will be dealt with in the next release.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201500615/1/

Meta data

Taxonomy: TM Cross Cutter , TM Basic Motion , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201500615
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.