The EtherCAT master does not start the EtherCAT (eliminated from 3200 C/p500 V3.6)
Eliminated from: 3200 C controller V3.6 p500 controller V3.6
Behaviour of the new version:
The EtherCAT master starts reliably even if in case of a boot project the EtherCAT is restarted shortly after starting the PLC application.
What happens? The EtherCAT does not start. The EtherCAT slaves do not change to the 'operational' state. The EtherCAT node is indicated with a red triangle in the PLC Designer.
When does the problem occur? If in case of a boot project the EtherCAT is restarted (EtherCAT_Master.xRestart:=TRUE) shortly after starting the PLC application has been started it may happen that the EtherCAT master is not started.
Which products are affected? 3200 C controller from V3.2 p500 controller from V3.3
Possible diagnostics? The IPC or PLC logbook does not include the message
Taxonomy:
Controller 3221 C
,
Controller 3231 C
,
Controller 3241 C
,
Controller 3251 C
,
Controller 3200 C
,
Controller p500
AKB-ID:
201208184
Last update:
2023/09/09
Category:
Version Informations
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
