Parameter transfer via Global Drive Control (elimination)
Which products are affected?
8200vector 0.25 - 90 kW (≥ SW 3.5) with standard I/O
8200motec 0.25 - 7.5 kW (≥ SW 3.5) with standard I/O
Eliminated function restriction?
Transferring parameter sets to the device via GDC was impossible, when the parameter set changeover was configured and active at the same time (e. g. parameter set 2). In this case, the parameter set transfer was aborted and the device indicated a 'CCr' trip or a 'CE5' trip. The communication between GDC and controller was interrupted. In case of the basic device this deficiency has been eliminated but it still exists when using an application I/O.
Taxonomy:
8200 vector frequency inverters
,
8200 motec frequency inverters
,
IO module bus FIF E82ZAFBC
,
IO module standard FIF E82ZAFSC
AKB-ID:
200406551
Last update:
2023/09/08
Category:
Version Informations
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
