L_TS2P_FlyingSaw: xSyncInInstant does not work correctly after switching on again (corrected from V3.26.0)

Corrected from:
Library: L_TS2P_TechModulesSynchronizingCamming (from V03.26.00)

Response of the new version:
After xSyncInInstant, synchronisation to the material position takes place immediately. This also applies after the process has been aborted, e.g. by xAbort.
What happens?
The target position to which xSyncInInstant synchronises is not correct after the process is stopped or cancelled.
 
When does the behaviour occur?
See description of behaviour.
 
Which products are affected?
L_TS2P_FlyingSawState from library L_TS2P_TechModulesSynchronizingCamming

Short-term measures:
-
 
Evaluation / recommendations:
-

Automatic Translation

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202200308/1/
Meta data
Taxonomy: Lib L_CM1P_ControlModules , Lib L_TB1P_TechnologyBasics , Lib L_TB2P_TechModulesBasic , Lib L_TF2P_TechModulesFollowingPositioning , Lib L_TP2P_TechModulesProcessFunctions , Lib L_TS2P_TechModulesSynchronizingCamming , Lib L_TW2P_TechModulesWindingTraversing , FAST Motion Modules V2
AKB-ID: 202200308
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form