L_TT1P_ElectricalShaftPosHigh: eTMState remains in SYNCHRONISING_POS when xSyncInstant = TRUE (corrected from V3.13)

Corrected from:
L_TT1P_TechnologyModules_LM (V3.13.0.7)
 
Response of the new version:
After clutching-in, the technology module state changes to POS_IS_SYNCHRONISED. 
What happens?
The technology module changes to the SYNCHRONISING_POS state and remains in this state although the clutch is clutched in.
 
When does this behaviour occur?
The xSyncInstant technology module input is set to TRUE.
 
Which products are affected?
L_TT1P_ElectricalShaftPosHigh function block from the L_TT1P_TechnologyModules_LM library (V3.12.0.9 and higher)
 
Evaluation/recommendations:
The technology module function is not impaired by this.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201500888/1/
Meta data
Taxonomy: TM Electrical Shaft Position , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201500888
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form