Target window (C3034) of the English-language GDC cannot be set with less than 6 units (remedied from V1.3 onwards)
Remedied from:
ECSxP Posi&Shaft V1.3 onwards
Behaviour of new version?
Whenever the English language variant of GDC is selected the target position window (C3034) can now be set within the complete code range starting with zero.
To be observed:
Unfortunately, this function restriction could not have been eliminated yet in the English pdb file which is installed via the device data update 5 (GU5.exe) for example.
The correct English pdb file will be provided in the next device data update 6 (GU6.exe) which is planned to be available at the end of February 2007.
Which products are affected?
ECSxP Posi&Shaft <=V1.2
What happens?
The target window (C3034) cannot be set with less than 6 units if the English-language variant of GDC is selected.
When does the problem occur?
The problem occurs whenever the English-language variant of GDC is used. Therefore, the problem is caused inside the English pdb file.
Possible diagnostics?
Entry of a value with less than 6 units under C3034 via the English-language version of GDC.
Short-term measures/recommendations?
Enter the value via the keypad or changeover the GDC language to German and enter the value there.
Evaluation:
If a smaller target window is required to be set the problem already occurs during commissioning and can be avoided by applying the short-term measures mentioned before.
