Deutschland (Germany)

- Difference description concerning the 9300 Servo PLC from V6.5 to V7.0

Function extensions
- Filtering the MCTRL_nNAct_a actual speed value
- Monitoring of the rotor position adjustment
- Motor phase monitoring
- Extension of the sine/cosine encoder monitoring
- Extension of the AIF_IO_Management system block

Eliminated function restrictions
- Absolute position of Hiperface encoders
- Drive indicates controller enable if the Rdy signal changes to FALSE
- Application RAM is not deleted
- Exceptional response 'Warning' does not activate a warning
- If errors of the message or warning type occur several times, the error remains active even if the causes of the malfunction have been removed
- C0856 by factor 10000 too large
- CAN telegrams are no longer received
- Torque limit in case of quick stop (QSP)
- Errors of the Fail-QSP type - the error message is repeatedly stored in the fault memory
- Error message: 'No program'
- Error messages of the Fail-QSP type are stored in the fault memory with a wrong offset
- L_CanGetRelocCobId function does not return the set value
- L_FWM function module
- No controller inhibit in case of a control reset
- Keypad indicates a wrong value for analog outputs
- LU message generates task overrun
- PEr error after TRIP reset
- Retain variables are not saved in a mode protecting against mains failure
-SYSTEM_bPLCResetAndRun without function
- Task overrun when PLC_PRG is deleted from the DDS project
- Behaviour during quick stop (QSP) with faulty feedback
- Default setting value for C1122 is too low

Compatibility with previous versions
Upwards compatible in terms of function.
Higher software versions support all functions included in the previous software versions.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200606092/1/

©

Contact form