SD7 and SD8 are not entered into the history buffer (remedied from B-SW V6.5)

Remedied from:
ECS axis module B-SW  V6.5

Behaviour of new version?
The error messages SD7 and SD8 are now correctly stored in the history buffer.


Which products are affected?
ECS axis module B-SW V3.0

What happens?
Error messages SD7 and SD8 are not stored in the history buffer.

When does the problem occur?
If SD7 and SD8 are in the first position of the history buffer and the mains is connected.

Possible diagnostics?
Manual control.

Short-term measures/recommendations?
None.

Evaluation:
Not critical since only the evaluation of the error cause later on is affected. The error response in case of an error is not influenced.

Published with service message No. 2004/26 and 2004/27

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200407042/1/
Meta data
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 200407042
Last update: 2023/09/08
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form