Corrected from:
Cabinet Controller 3200C V3.21.1
Panel Controller p500 V3.21.1
Response of the new version:
If a boot project is saved on the controller, the controller starts the PLC processing after power on.
What happens?
After switching on, it can happen that the controller does not start the PLC processing. In this case, it is not possible to log into the controller with the PLC Designer. For units with a display, the message appears:
Application PlcV3WinCe.exe encountered a serious error and must shut down.
When does the behaviour occur?
The behaviour can occur in very rare cases after switching on if a CAN card is installed in the controller.
Which products are affected?
Cabinet Controller 3200C
Panel Controller p500
Short-term measures:
Switch the controller off and on again.
Evaluation / recommendations:
Due to this functional restriction, the controller does not start with the PLC processing. The remedy is to switch the controller to mains.
Automatic Translation
