Update of the synchronisation parameters (remedied from V1.05)
Remedied from:
Communication module E94AYCEP Firmware V1.05
Behaviour of the new version
New synchronisation parameters are automatically accepted after a project download.
Which products are affected?
Communication module E94AYCEP Firmware V0.51
What happens?
The newly configured synchronisation parameters are not accepted after a project download.
When does the problem occur?
If the synchronisation parameters are changed by means of the Engineer and subsequently transferred by means of a project download, the new synchronisation only becomes effective after mains switching.
Possible diagnostics?
The behaviour described before has occurred if the newly configured synchronisation parameters do not immediately become effective.
Short-term measures/recommendations?
Carry out mains switching when new parameters which are relevant for the synchronisation have been transferred.
Evaluation:
With firmware version 1.05, new synchronisation parameters are automatically accepted after a project download.
