Remedied from?
GDC 4.8, GDC 4.8 Update and GDC easy
Behaviour of the new version?
When creating the comparison table the columns to be compared are assigned correctly in the representation mode 'PC Parameter value – Drive controller value'.
Which products are affected?
GDC 4.7, GDC 4.7 Update or GDC 4.7 easy in combination with a 9300 servo inverter
What happens?
The two columns shown in the comparison mode are mixed up.
When does the problem occur?
When comparing the parameter sets in the representation mode:
'PC Parameter value – Drive controller value'
Possible diagnostics?
In the GDC menu bar under menu item 'Drive parameters => Compare actual parameter set…=> PC parameter value - drive value' the comparing function can be selected.
Short-term measures/recommendations?
Use GDC 4.8
Evaluation:
Due to the confused representation the compared codes may be interpreted incorrectly.
