Reset (original) does not delete Application RAM 1and 2 (remedied from B-SW V6.6)

Remedied from:
ECS axis module B-SW  V6.6

Behaviour of new version?
The application RAM is deleted correctly.


Which products are affected?
ECS axis module B-SW ≥ 3.0 and V6.5

What happens?
Application RAMs 1 and 2 have not been set to zero. There is still some data in the memory left.

When does the problem occur?
During mains connection or if a reset (original) is executed.

Possible diagnostics?
None.

Short-term measures/recommendations?
Delete the RAMs mentioned above manually.

Evaluation:
A manual deleting of the application data is required.

Published with service message No. 2004/44 and 2004/45

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200500043/1/
Meta data
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 200500043
Last update: 2023/09/08
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form