Units of some codes are not displayed correctly in GDC (remedied from B-SW V6.5)

Remedied from:
ECS axis module B-SW  V6.5

Behaviour of new version?
The units of some codes which have previously been indicated incorrectly are now displayed correctly in GDC.


Which products are affected?
ECS axis module B-SW V3.0

What happens?
Certain codes are displayed without or with incorrect physical units.

When does the problem occur?
The incorrect units are always indicated.

Possible diagnostics?
The displayed code units are not correct.

Short-term measures/recommendations?
None.

Evaluation:
Not relevant for the actual functionality. The handling is partly restricted.

Published with service message No. 2004/26 and 2004/27

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200407043/1/
Meta data
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 200407043
Last update: 2023/09/08
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form