C0086, Lenze setting of the 9300 drive controller

Question:

Which Lenze motor in connection with 9300 servo inverters is entered in Lenze factory default setting in code C0086?

Answer:

The Lenze factory default setting of the Lenze motor set in C0086 depends on the power size of the device. The attached table shows each Lenze setting.


URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200400520/1/
Meta data
Taxonomy: 9300 vector EVF93xx-EH hoist frequency inverters , 9300 vector EVF93xx-EV frequency inverters , 9300 vector frequency inverters , 9300 Cam Profiler (EK) servo inverters , 9300 Position Controller (EP) servo inverters , 9300 Register Controller (ER) servo inverters , 9300 Servo PLC Logic (EI) servo inverters , 9300 Servo PLC Technology (ET) servo inverters , 9300 Standard Servo (ES) servo inverters , 9300 servo inverters
AKB-ID: 200400520
Last update: 2024/01/11
Category: FAQ, Tips and Tricks

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.

Further information

Contact form