c430: It is not possible to set the IP interface of port X396 / X397

Removed from:

Behavior of the new version:

Description of behavior:

The MAC address 000000000000 is used for the X396/X397 interface when used as an Ethernet switch.

The Ethernet interface cannot be used in this case. No IP address or subnet mask can be set.

Conditions under which the behavior occurs:

An SD card was used in the device that was previously used in a c520 or c550.

Affected products:
Controller C430

Short-term measures, Recommendations, Rating:

Follow these steps:

Download the file c430.zip file from the attachment and unzip it. The file contains two directories ("firmware" and "plc").
Switch off the controller.
Remove the SD card from the controller to a PC
Delete the directories "firmware" and "plc" directories from the SD card
Copy the "firmware" and "plc" directories from the zip file to the SD card.
Insert the SD card into the c430 and start it
As long as the STA LED is lit, the controller must not be switched off.

After the restart, the firmware V1.14 is installed on the c430 and the MAC address is valid.

[Automatic Translation]