Corrected from:
Cabinet Controller c300 V3.20.1
Panel Controller p300 V3.20.1
Response of the new version:
After performing an update or a restore, the controller is automatically restarted.
What happens?
During the execution of an update or restore process, the Lenze controller is automatically restarted several times. It may happen that
this restart is not carried out automatically, but the controller stops in the update or restore process.
When does the behaviour occur?
The behaviour can occur sporadically during an update or restore.
Which products are affected?
Cabinet Controller from V3.8
Panel Controller as of V3.8
Short-term measures:
Start the update or restore as usual. If the S1 LED of the controller flashes green for more than 15 minutes, switch the controller off manually and then on again.
The update or restore will then be completed without errors.
Evaluation / recommendations:
The update/restore is not automatically completed by restarting the controller. How to proceed in this case is described under 'Short-term measures'.
Automatic Translation
