Error message "Fatal Error 222" (corrected from V3.18.1)
Corrected from:
Cabinet-Controller 3200C V3.18.1
Response of the new version:
After a firmware update no error message "Fatal Error 222" is displayed.
What happens?
The message concerning the backplane bus appears in the logbook of the controller:
Fatal Error 222
When does the behaviour occur? The error message can occur the first time the controller is started after a firmware update.
Which products are affected?
Cabinet-Controller 3200C
Short-term measures:
Switch the controller off and on again after a firmware update.
Evaluation/Recommendations:
A firmware update is carried out with a prepared USB stick and is carried out, if at all, during the commissioning phase or in case of a controller replacement. The error message can be reset by reconnecting the controller to power.
Taxonomy:
Controller 3221 C
,
Controller 3231 C
,
Controller 3241 C
,
Controller 3251 C
,
Controller 3200 C
AKB-ID:
201900076
Last update:
2023/09/09
Category:
Versions-Informationen
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
