Extension of the Id8 error message: speed sensor not set

Which products are affected?

Inverter Drives 8400 StateLine, HighLine, and TopLine from firmware version 14.00.00.00

Functional description

The Id8 error message has been added, which is tripped if the control mode (C006) with feedback has been selected, but no speed sensor (C495) is set. The error message is set if an edge change from controller inhibit to controller enable is effected.

The error can only be reset if the control mode and the encoder setting comply with each other. The response is set to "Fault" by default (C571/2=1).


URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201500614/1/
Metadaten
Taxonomy: 8400 StateLine frequency inverters , 8400 HighLine frequency inverters , 8400 TopLine frequency inverters
AKB-ID: 201500614
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Kontaktformular