Eliminated from:
9400 HighLine SW V10.00.12.00
9400 ServoPLC SW V04.00.12.00
Behaviour of the new version?
The information is only written into the logbook if the entire saving process has been completed successfully.
What happens?
The 'Parameter set saved' information is entered in the logbook although the saving process (save parameter set with C00002 = 11) has not been completed yet – e. g. when the device is switched off during the saving process.
When does the problem occur?
The 'Parameter set saved' information is already written into the logbook during the saving process (save parameter set with C00002 = 11).
If the export of the parameter set (internal component of the parameter set saving) fails or requires a lot of time (device utilisation) this message can be misleading.
Which products are affected?
9400 HighLine SW ≤ V09.00.09.00
9400 ServoPLC SW ≤ V03.00.17.00
Possible diagnostics?
Analysis of the logbook time stamps
Short-term measures/recommendations?
None.
Evaluation:
The behaviour occurs very rarely.
