Eliminated from:
StateLine / HighLine with firmware version V05.01 or higher
Behaviour of the new version?
This function restriction is eliminated with the above-mentioned firmware version.
LU is only displayed if:
• BU off / CU off ► BU(off) / CU(on) (after 4 s)
• BU on /CU on ► BU(on) / CU(on)
• BU on /CU on ► BU(off) / CU(off)
(BU = power section; CU = control card)
Which products are affected?
8400 StateLine / HighLine with FW < 05.01
What happens?
LU is entered into the Logbook when the devices are connected to the mains.
When does the problem occur?
When the 8400 is connected to the mains.
Possible diagnostics?
Check Logbook entries after mains connection.
Short-term measures / recommendations?
None
Evaluation:
Just an incorrect Logbook entry; the operational performance is not affected as long as LU is not configured as a status determining error (Fault).
Information taken from chapter 1.1.39 of
Service Message No. 16/2010.
