Homing cannot be started at C4000 = 1 (corrected from V2.0)

Corrected from:
ECS Motion V2.0

Behaviour of the new version?
Homing can now always be started, irrespective of the setting under code C4000.


Which products are affected?
ECS Motion V1.2

What is the response?
Homing cannot be started by the higher-level control.

When does the problem occur?
If code C4000 = 1 is set.

Diagnostics options?
Homing does not start.

Short-term measures/recommendations?
Set C4000 = 0.

Evaluation:
Only occurs very rarely, since C4000 normally is not used.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200905105/1/
Metadaten
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 200905105
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Kontaktformular