Remedied from:
ECS axis module V8.0
Not yet remedied from: EPL-10200 (Drive PLC)
Not yet remedied from: EVS93xxEI (Servo PLC)
Not yet remedied from: EVS93xxET (Servo PLC with technology function)
Behaviour of new version?
The following codes for synchronising the drive have been added under the keypad menu item 'System bus>Sync-Managem'.:
- C1120 Sync signal source
- C1121 Synchronisation cycle
- C1122 Synchronisation phase
- C1123 Synchronisation window
Which products are affected?
EPL-10200 (Drive PLC V8.1 and lower)
EVS93xxEI (Servo PLC V7.2 and lower)
EVS93xxET (Servo PLC with technology function V7.2 and lower)
ECS axis module V7.4 and lower
What happens?
The following codes for synchronising the drive are missing under the keypad menu item 'System bus>Sync-Managem'.:
- C1120 Sync signal source
- C1121 Synchronisation cycle
- C1122 Synchronisation phase
- C1123 Synchronisation window
When does the problem occur?
The codes mentioned above are missing under the keypad menu item 'System bus>Sync Managem'.
Possible diagnostics?
None.
Short-term measures/recommendations?
Codes C1120 until C1123 can be accessed via the keypad menu item 'Code list'.
Evaluation:
Under the keypad menu item 'System bus>Sync-Managem' four codes which are displayed in the GDC software or on the parameter monitor (DDS) are missing. These codes can be accessed via the keypad menu item 'Code list'.
Published with service message No. 2008/08 and 2008/09
