PEr error after TRIP reset (remedied from B-SW V7.0)

Remedied from:
ECS axis module B-SW V7.0

Behaviour of new version?
Due to the use of the L_FWM function block a PEr error no longer occurs after a TRIP reset.


Which products are affected?
ECS axis module B-SW V3.0, V6.7

What happens?
The PEr error occurs after a TRIP reset.

When does the problem occur?
Sporadically, when using the L_FWM function block for errors, warnings and messages.

Possible diagnostics?
None.

Short-term measures/recommendations?
Do not use the L_FWM function block.

Evaluation:
The error message does not occur if the L_FWM is not used.

Published with service message No. 2006/14 and 2006/15

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200603193/1/
Metadaten
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 200603193
Last update: 2023/09/08
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Kontaktformular