Which products are affected?
ESP-DDS2-P (Global Drive PLC Developer Studio Professional V2.x)
What happens?
The zoom function in the function bar of DDS can be used to enlarge or reduce (zooming) the view of all graphical editors and the visualisation.
When enlarging the view of a POU programmed in sequential function chart (SFC), the names of the transitions are cut off horizontally, i. e. the lower part of the transition name is no longer displayed.
When does the problem occur?
The behaviour described above occurs if a zoom value higher than 100 % was set in the function bar.
Possible diagnostics?
None.
Short-term measures/recommendations?
Set a zoom value of 100 % in the function bar.
Evaluation:
In this function restriction, transition names are not fully displayed when enlarging the view in the SFC editor. This function restriction only affects the graphical display of the logic, but does not have any influences on its correct execution. In the DDS standard settings, a zoom value of 100 % was set.
