Parameter set transfer via keypad, code C0140

Which products are affected?

8200 vector / motec (software ≤ V3.1)

What happens?

Code C0140 (NSET1-NADD) is not transferred when transferring parameter sets by means of the keypad.

When does the problem occur?

When transferring parameter sets via keypad.

Possible diagnostics?
  • Monitoring of code C0140
  • no setpoint selection after a parameter set transfer if C0140 is the setpoint source

Short-term measures/recommendations?
  • Re-enter the value manualle under C0140
  • Parameter set transfer via GDC

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/20031156/1/
Metadaten
Taxonomy: 8200 motec frequency inverters , 8200 vector frequency inverters
AKB-ID: 20031156
Last update: 2023/09/08
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Kontaktformular