L_TS2P_SyncAndCorrection: No warning appears after failure of the maximum allowed marks (ToolCorrection) (fixed as of V3.23.0)

​Corrected from:
Firmware i950: 1.6 (Update via EasyPackageManager or Firmware Loader)
Library: L_TS2P_TechModulesSynchronizingCamming V3.23.0.20 (Update via Easy Package Manager)

Response of the new version:
The warning "MaxMissedMarks" is issued when the maximum number of allowed mark failures has occurred.

What happens?
The technology module does not issue a warning.

When does the behaviour occur?
The tool offset is used.
The marker window of the tool offset is activated.
More marks fail than the maximum allowed.

Which products are affected?
L_TS2P_SyncAndCorrectionState from the library L_TS2P_TechModulesSynchronizingCamming  
i950 Servo Inverter with TA SyncAndCorrection

Short-term measures:
None

Automatic Translation

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202100033/1/
Metadaten
Taxonomy: Lib L_CM1P_ControlModules , Lib L_TB1P_TechnologyBasics , Lib L_TB2P_TechModulesBasic , Lib L_TF2P_TechModulesFollowingPositioning , Lib L_TP2P_TechModulesProcessFunctions , Lib L_TS2P_TechModulesSynchronizingCamming , Lib L_TW2P_TechModulesWindingTraversing , FAST Motion Modules V2
AKB-ID: 202100033
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Kontaktformular