L_MC1P, L_MC2P, L_MC4P: Standard visualizations of V03.20.00 can only be used with PLC-Designer from V03.20.00 on (no change intended)

Corrected from:
Library:  L_MC1P_MotionControlBasic (FAST Motion)  (no change intended)
               L_MC2P_MotionControlCam  (FAST Motion)  (no change intended)
               L_MC4P_RoboticHandling (FAST Motion)        (no change intended)
 
Response of the new version:
A change of the behavior is not possible due to the principle.
 
 
 
What happens?
The standard visualizations for the function blocks from the library are only available from PLC-Designer V03.20.00.
In previous PLC-Designer versions, the new visualizations are not displayed and cannot be used in the program.
 
When does the behaviour occur?
Use of the PLC Designer in an older version <= V03.19.00 for program creation with the new libraries L_MC1P, LMC2P, L_MC4P from V03.20.00.

Which products are affected?
Library:       L_MC1P_MotionControlBasic  (FAST Motion)
                     L_MC2P_MotionControlCam  (FAST Motion)
                     L_MC4P_RoboticHandling (FAST Motion)

Short-term measures, Evaluation / Recommendations:
Use new PLC-Designer version V03.20.00 or higher.
The new version of PLC-Designer is available for download from the Lenze homepage. 

Automatic Translation

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202000007/1/
Metadaten
Taxonomy: Lib L_MC1P_MotionControlBasic , Lib L_MC2P_MotionControlCam , Lib L_MC4P_RoboticHandling
AKB-ID: 202000007
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Kontaktformular