L_TT1P_RegisterControl: Mark correction with TP outside the window (eliminated from V3.16.0)

Eliminated from:
L_TT1P_TechnologyModules_LM (from V3.16.0.62)

Behaviour of new version:

If a touch probe event occurs outside of the parameterized mark window, it is ignored. There is no position correction.

What happens?

A mark is corrected. The cut is triggered at a wrong position.

When does this behaviour occur?

The behaviour occurs when the RegisterControl technology module is used with touch probe in a window and touch-probe events occur outside the window.

Which products are affected?
L_TT1P_RegisterControl in the L_TT1P_TechnologyModules_LM library (from V3.15.1.4)

Short-term measures:

Do not use any touch-probe window or only pass on touch-probe events to the RegisterControl technology module (xMarkReceive) if they are inside the window.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700361/1/

Metadaten

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201700361
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.