L_TT1P_TablePositioning: Axis sporadically performs an additional revolution in the Relative_TP mode (eliminated from V3.16.0)

Eliminated from:
L_TT1P_TechnologyModules_LM (ab V3.16.0.62)

Behaviour of new version:

The axis correctly executes the specified relative movement after the touch-probe has occurred.

What happens?

Instead of the specified relative movement, the axis makes an additional revolution.

When does this behaviour occur?

The Relative_TP mode is used for profile switch-over. The touch-probe event occurs simultaneously with a modulo overflow of the axis.

Which products are affected?

L_TT1P_TablePositioning in the L_TT1P_TechnologyModules_LM library (from V3.15.0.32)

Short-term measures:

There is no applicative short-term measure available.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700296/1/

Metadaten

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201700296
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.