L_TT1P_RegisterControlState: Error when TP occurs during mark correction

What happens?

The cuts no longer remain within mark control.

When does this behaviour occur?

The behaviour occurs when from a certain speed the next TP occurs during the correction movement of the previous TP.

Which products are affected?
L_TT1P_RegisterControlState in the L_TT1P_TechnologyModules_LM library (V3.14.2.58 and higher)

Short-term measures:

Use the parameters lrUpperCorrPos, lrLowerCorrPos and shift the compensating movement such that it will already be completed when the next TP occurs.

Evaluation/recommendations:

If the above short-term measure is observed, the behaviour will be correct.

No change is planned for this behavior.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700178/1/

Metadaten

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201700178
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.