L_TT1P_PickAndPlaceHigh: The TM writes into an invalid area outside an array (corrected from V3.14.1)

Corrected from:
L_TT1P_TechnologyModules_LM (V3.14.1.41)

Response of the new version:

The TM does not perform any impermissible accesses to undefined memory areas of the controller. Positions other than those set in the profile are not approached.

What happens?

Other positions than those set in the profile are approached.

When does this behaviour occur?

Whenever the profile is started, the TM once writes to an invalid memory area.

Which products are affected?
L_TT1P_PickAndPlaceHigh from the L_TT1P_TechnologyModules_LM library (V3.14.0.21 and higher)

Short-term measures:

No short-term measure

Evaluation/recommendations:

The above-described function restriction is considered as a critical error. The maloperation may cause damage to machinery. The L_TT1P_TechnologyModules_LM library in V 3.14.0.21 is blocked and must not be used.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700026/1/

Metadaten

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201700026
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.