L_TT1P_RegisterControl: Mark error calculation is sporadically incorrect (eliminated from V3.13.1)

Eliminated from:
L_TT1P_TechnologyModules_LM (ab V3.13.1.25)

Behaviour of new version:

The error does not occur anymore. All mark errors are calculated correctly.

What happens?

Sporadically, the calculated mark error is incorrect. In this case, the technology module performs an incorrect position correction for the corresponding mark.

When does this behaviour occur?

The Register Control technology module performs a position correction for the marks on a conveyor.

Which products are affected?

L_TT1P_RegisterControl function block from the L_TT1P_TechnologyModules_LM library (from V3.12.0.9)

Short-term measures:

Use library 3.10.x.x

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201600077/1/

Metadaten

Taxonomy: TM Register Control , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201600077
Last update: 2023/09/09
Category: Versions-Informationen

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.