Instantaneously wrong output signal at the output of the edge element (F_TRIG) (elimination)

Which products are affected?
EVS93xx-EI (Servo PLC, software version 2.3)
EVS93xx-ET (Servo PLC, software version 2.3)
EPL 10200 (Drive PLC, software version 6.1)

Function restriction corrected
The module F_TRIG will not indicate TRUE at output Q for the initial function block call after a control reset if the input CLK of the function is assigned with FALSE. Only if the edge changes from TRUE to FALSE at input CLK the output Q is set to TRUE for one program cycle only.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200408615/1/