L_TT1P_RegisterControlState: Incorrect correcting motion (eliminated from V3.13)

Eliminated from:
L_TT1P_TechnologyModules_LM (ab V3.13.0.7)

Behaviour of new version:

The correction process for the technology module Register Control is always terminated without jump.

What happens?

The correction process for position correction of the RegisterControl technology module is completed with a jump.

When does this behaviour occur?

The behaviour occurs always. Since the not corrected position differences are adding up, the error mainly shows effect when using a mark stack.

Which products are affected?
L_TT1P_RegisterControlState function block from the L_TT1P_TechnologyModules_LM library (V3.12.0.9 and higher)

Short-term measures:

If possible, do not use the mark stack in this technology module version.

As an alternative, you can use an earlier technology module version.

Evaluation/recommendations:

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201600131/1/

Meta data

Taxonomy: TM Register Control , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201600131
Last update: 2023/09/09
Category: 版本注释

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.