L_Transient FB - no output signal (eliminated from V5.0 onwards)

Eliminated from:
StateLine / HighLine with firmware version V05.01 or higher

Behaviour of the new version?
This function restriction is eliminated with the above-mentioned firmware version.

---

Which products are affected?
8400 StateLine / HighLine with FW < 05.01

What happens?
If a setting of 1 ms is selected, no output signal is generated.

When does the problem occur?
If the L_Transient FB is used with a setting of 1 ms.

Possible diagnostics?
Output signal not available.

Short-term measures / recommendations?
Select settings > 1 ms.

Evaluation:
The error can be avoided if the recommendations are followed.

Information taken from chapter 1.1.47 of Service Message No. 16/2010.