Error in the ¨System bus monitor CAN-IN2¨ dialog (remedied from V4.7)

Remedied from?
GDC 4.7 and GDC easy 4.7

Behaviour of the new version?
Motor dialogs indicating the status and the link are available for the process data inputs of the different system bus CAN fieldbus function modules. If a link of the CAN-IN2-W2-Bit2 signal is parameterised, this is indicated correctly on the system bus monitor CAN-IN2.

---

Which products are affected?
GDC 4.6.1 and GDC easy 4.5

What happens?
When linking the CAN-IN2-W2-Bit2 signal the system bus monitor CAN IN2 indicates the corresponding link at CAN-IN2-W2-Bit3.

When does the problem occur?
Motor dialogs indicating the status and link are available for the process data inputs of the different system bus CAN fieldbus function modules. If a link of the CAN-IN2-W2-Bit2 signal is parameterised, this is indicated at CAN-IN2-W2-Bit3. However, the internal link is carried out correctly.

Possible diagnostics?
If the CAN-IN2-W2-Bit2 is linked and this link is indicated in the system bus monitor view at CAN-IN2-W2-Bit3, this may indicate that the faulty behaviour described before has occurred.

Short-term measures/recommendations?
The error has been eliminated in GDC 4.7 and GDC easy 4.7.