- Difference description concerning the GDC Software from V4.6 to V 4.7

Function extensions:
- Integration of the ECS servo system
- starttec motor starter with 4 parameter sets
- Extension of the input assistant for motor data
- Writing string codes

Eliminated function restrictions:
- Configuration file: System bus configuration tool
- OPC-DECOM settings (Remote, ActiveX)
- GDC is closed during storage in a non-volatile mode
- PDB ServoPLC Version 6.2 - 6.X: Motor data assistant
- Error in the 'System bus monitor CAN-IN2' dialog
- 8200 vector/motec: Controller inhibit during parameter set transfer
- 8200 vector/motec: Output configuration dialog
- 8200 vector/motec: Commissioning assistant
- Motor data are immediately read out when staring the commissioning assistant of the 8200 vector/motec
- 8200 vector/motec: Code C0360 and the parameter set transfer

Compatiblity with previous versions
Upwards compatible in terms of function.
Higher software versions support all functions included in previous software versions.

Function extensions (Intranet only)
- Aborting the search function during OPC communication


Further information is provided in Service Message No. 39/2004.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200414119/1/
Meta data
Taxonomy: Global Drive Control
AKB-ID: 200414119
Last update: 2023/09/14
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Formulario de contacto