Transfer of parameter sets from the PC to the drive controller
Question:
Which codes are not transmitted from the PC to the drive controller when the parameter sets are transmitted by GDC?
Answer:
When parameter sets are transmitted from the PC to the drive controller by GDC two transfer versions can be selected: 'Duplicate' or 'Replacement device'. When the corresponding transmission is executed the codes listed in the attachment are - dependent on the plugged FIF module - not transmitted.
Taxonomy:
Global Drive Control
,
8200 vector frequency inverters
AKB-ID:
200602283
Last update:
2024/01/11
Category:
Foire aux questions (FAQ), conseils et astuces
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
