FAST Motion with i700 (part 4): How to configure softmotion axes?

​FASTMotionWithi700_ConfigureMotion_Thumbnail.png

Content:

  1. Set up soft motion axes
    1. Change name of the axes
    2. Open tab 'Settings' of the motion axis
    3. Set 'Mechanical data'
  • Mounting direction
  • Gear ratio ('Gear numerator' and 'Gear denominator')
  • Traversing range
  • Set 'Basic settings'
    • Disable 'Following error'
  • Set 'Homing'
  • Set 'Position controller'
  • Going online and check functionality
    1. Select 'Manual control' of the drive
    2. Set parameter for manual control in the dialog 'Manual motor rotation indication'
    3. Start operation
  • Create boot application

    • Duration:
    05:13 min​


    Video:

    How to configure softmotion axes & how to use manual control?


    Link list​:

    Next video: How to insert an AxisBasicControl function block?

    Previous video: How to add an i700 in the PLC project?


    You will find more information about the Lenze training on the Lenze Website: Training Service


    URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202400208/1/
    Meta data
    Taxonomy: PLC Designer V3.x , i700 axis module E70ACM , i700 axis module E70BCM , i700 power supply module E70ACP , i750 axis module i75A , i700 servo inverters , L_MC1P_MotionControlBasic
    AKB-ID: 202400208
    Last update: 2026/04/27
    Category: Videos

    Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.

    Further information

    Écrire à Lenze