L_TT1P_Smart Track: Correction is not performed (fixed from V3.20.0)

Fixed:
Library: L_TT1P_TechnologyModules_LM as of V03.20.00.78
(Update via Easy Package Manager)

Behaviour of the new version:

The correction is limited to a maximum value of half the remaining tape length.

Description of the behaviour:

The correction run is not performed.
xCorrectionBusy is TRUE for one cycle only

Under what conditions does the behaviour occur?

This behavior occurs when the correction is not limited and is to be extended completely to the correction distance.

Affected products:
L_TT1P_SmartTrack from library L_TT1P_TechnologyModules_LM

Short-term measures:

The correction limit must be set to half the remaining tape length. Then the behavior doesn't occur.

Automatic Translation

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201900156/1/

Meta data

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201900156
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.