Some technology modules require a much longer runtime than before (corrected from V3.18.2)

​Corrected from:
Library: L_TT1P_TechnologyModules_LM V03.18.02.02
                    (update via Easy Package Manager)
 
Response of the new version:
The runtime corresponds to the runtime indicated in the documentation.
 
What happens?
Under certain circumstances, a set task watchdog may be triggered as a result and stop the PLC application. 
 
When does this behaviour occur?
The behaviour occurs when the below-indicated technology modules are used in the specified versions.
 
Which products are affected?
The following technology modules from the L_TT1P_TechnologyModules_LM library (in V3.18.00.33 and V3.18.01.04) are affected:
  • L_TT1P_CrossCutterBase
  • L_TT1P_CrossCutterState
  • L_TT1P_RegisterControlBase
  • L_TT1P_FlyingSawBase
  • L_TT1P_FlyingSawState
 
Short-term measures:
The technology modules from the previous L_TT1P_TechnologyModules_LM library (V3.17.00.47) do not have longer runtimes.
 
Evaluation/recommendations:
When using the above technology modules, the runtime of the PLC application will be longer.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201900085/1/
Meta data
Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201900085
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form