L_TT1P_MagicTrack: "InvalidProfile" error message (corrected from V3.16.0)

Corrected from:
Library: L_TT1P_TechnologyModules (FAST Motion) V03.16.00.62
(update via AKB)

Response of the new version:

When operating the technology module in "Automatic" mode, the "InvalidProfile" error message no longer appears.

What happens?

The technology module outputs the "InvalidProfile" error.

When does this behaviour occur?

Infeed and outfeed positions are parameterised as follows:

Infeed = whole cycle,

Outfeed = whole cycle + track length

Which products are affected?

L_TT1P_MagicTrack in the L_TT1P_MagicTrack library (V3.14.0.42 and higher)

Short-term measures:

Select Position = 0 instead of Position = cycle length as infeed position.

Select a value slightly higher than track length + safety distance as distance between infeed and outfeed.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201800008/1/

Meta data

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201800008
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.