L_TT1P_TablePositioning: Axis continuously traverses in one direction (eliminated from V3.12)

Eliminated from:
L_TT1P_TechnologyModules_LM V3.12.0.9

Behavior of new version:

The positioning is done with the profile parameters of the first profile. An endless movement in one direction does no longer occur.

What happens?

The positioning axis continuously traverses with the speed of the first profile in one direction

When does this behaviour occur?

The behaviour occurs if a profile linkage with final speed in the first profile and a relative sequence profile is cancelled with xHalt while executing the relative profile and

the positioning process is restarted with xExecutePositioning after this.

Which products are affected?

L_TT1P_TablePositioning function block from the L_TT1P_TechnologyModules_LM library (V3.10.0.8 and higher)

Short-term measures:

Do not use the above-mentioned profile configuration until the function restriction has been removed.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201500810/1/

Meta data

Taxonomy: TM Table Positioning , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201500810
Last update: 2024/01/19
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.